Create a beautiful Necklace

Create a beautiful Necklace

Project Process in steps

Step 1
Cut a long length of cord and start to thread on the beads. Tie a knot before and after each bead has been threaded to hold it in place. Then, add the necklet ends, jump rings and toggle clasp.

Create a beautiful Necklace
Create a beautiful Necklace

Step 2
Roll out the PMC and form it over a bead to create a decorative bead cap, allow for the clay to shrink a little. Once it has completely dried out, fire the clay using the Dremel Versaflame.

Create a beautiful Necklace
Create a beautiful Necklace

Step 3
Use the Dremel Engraver and engraver tip diamond (9929) to add a scroll design over the silver bead cap. Polish the bead cap using the Dremel Stylus together with the Dremel EZ SpeedClic polishing wheel (423S) By applying some polishing compound 421 during the process you will achieve the best finish. Thread the bead onto the head pin, then the bead cap over the bead. Bend the end of the head pin into a loop with the pliers and attach it to the centre of the necklace.

Create a beautiful Necklace
Create a beautiful Necklace

Other Supplies

  • Toggle clasp
  • Necklet end x 2
  • Black cord 1mm thick
  • Assortment of beads & large disc bead
  • 2 jump rings 5mm
  • ½ round cutting pliers
  • Head pin x 52mm
  • Precious Metal Clay
  • Firing block
  • Tweezers