jump to main content

Changing the tiling around your toilet

projectpicture for step1

Step 1

Chip off your old tiles using a chisel and hammer and make good, sanding so that the surface is smooth – or, if necessary, get the wall skimmed, as you need a perfectly even surface on which to tile.

projectpicture for step2

Step 2

Measure your wall dimensions and your tiles to create a plan for your tiling. Then find the centre of the wall and decide your tiling plan working from the centre towards the outside edges/corners to give yourself even tile cuts at either end.

projectpicture for step3

Step 3

In order to start to tile using your plan, ensure that you remove your toilet flush plate so that you can tile up to the service hole. Apply adhesive evenly all over the wall. Then, accurately apply the whole new tiles using tile spacers to ensure they are all equally spaced apart from each other.

projectpicture for step4

Step 4

Cut the remaining tiles for the wall edges, corners, around the service hole and the back of the toilet using your Dremel DSM20 compact saw and the Dremel DSM Edge Guide and the Dremel DSM540 Diamond Tile Wheel.

projectpicture for step5

Step 5

Apply the cut tiles to the wall, following your design.

projectpicture for step6

Step 6

Finish off by grouting and when that’s dry, screw in a toilet roll holder – or even better, apply one with a suction pad so there’s no need to drill - and you’re done!

related products

Other supplies

Chisel and hammer

Tile adhesive

Tile spacers

New tiles

Grout and grouting pad

Tape measure and pencil

Sandpaper