jump to main content

Create a 'window' and increase the size of your balcony...

Ever wanted to add a touch of glamour to your balcony with a decorative feature? Well, how about creating a 'window' to bring the outside in! See our step-by- step guide below using your new Dremel® DSM20 Compact Saw.

projectpicture for step1

Step 1

Measure your balcony wall, considering what you want to reflect in the 'window'. Then, decide on the dimensions of your mirror decorative wall feature. Work out the other measurements according to the size of mirror and frame you want to construct.

projectpicture for step2

Step 2

Take your Dremel DSM20 compact saw with the DSM500 Multi-Purpose Cut-Off Wheel to cut the individual lengths of wood, as detailed above in our cutting list, in order to make the wooden frame for the mirror. Use the DSM840 cutting guide to assist in the cutting.

projectpicture for step3

Step 3

Use your Dremel Glue Gun and wood glue, glue and pin one x 6mm MDF strip to the underside of each side of the frame. This will create the rebate for the mirror. Fit one of each of the MDF strips flush to the edge of the wooden frame.

projectpicture for step4

Step 4

Fix the side and bottom edge of the frame to the backing board by screwing through the backing board into the back of the frame using a manual screwdriver or a powered driver and a 35mm screw.

projectpicture for step5

Step 5

Slide the mirror into the rebate you have created within the frame. Repeat the process to finish the frame construction ensuring that you screw away from the mirror and rebate.

projectpicture for step6

Step 6

Mark up where your hinges of your bought louvre doors should go e.g. 10cms from the top and again from the bottom. Mark up the corresponding places on the frame where the hinges will attach the louvre door to the frame. Do this on both sides. Rebate the hinge on the doors by 2mm using the Dremel Plunge Router Attachment 335 and the router bits 615 and 650.

TIP: It is important to note where you are putting the hinge on over the rebate to avoid screwing through into the mirror – we used 15mm screws for the hinges allowing a clearance of 5mm.

projectpicture for step7

Step 7

Finally, prime your mirror frame with white primer, make sure that you prime all the exposed edges of the MDF. Paint with exterior colour over the top and leave to dry. Take your Dremel 3000 and EZ SpeedClic sanding disc SC413 and distress the top surface so that some of the white primer shows up from underneath. Secure your mirror to the outside wall of your balcony using heavy duty picture brackets that will support a lot of weight.

related products

Other supplies

Wood for mirror frame cutting list:

80.4 cms w x 101.2cms l x 18mm d MDF (backing board)

2 lengths: 65.2cm l x 7.5cm w x 6mm d MDF (spacing strips for underside of frame)

2 lengths: 101.2cm l x 7.5cm w x 6mm d MDF (spacing strips for underside of frame)

2 lengths: 9.5cms w x 2cm d x 101.2 lcms softwood (sides of the frame)

2 lengths: 9.5cms w x 2cm d x 61.7 lcms softwood (top and bottom of the frame)

Screwdriver or powered driver

Mirror: 65cms w x 85.8cms l x 6mm d glass

Louvre doors: 81.7cms l x 30.7cms w x 22mm d

4 x heavy duty picture brackets

Tape measure


Metal pins