jump to main content

Create a Cut Egg Decoration

Using the 225 Flex Shaft attachment removes the weight of the tool from your hand and allows for precise and delicate movements. For best results, start at the centermost part of the egg and work outward. The SC545 EZ SpeedClic diamond wheel is a very thin, fine wheel. It is used most successfully at speeds less than 20,000 rpm. Faster speeds may cause the wheel to get too hot and bend under pressure. Engraving cutters 111 and 106 need a 481 collet.

projectpicture for step1

Step 1

Pierce a small hole in both ends of an extra large egg. Blow with your mouth on one end to expel the entire contents of the egg. Wash and rinse the egg in warm water and set aside to dry.

projectpicture for step2

Step 2

Use a pencil to lightly draw lines or a design on the egg. The lines will be carved away.

projectpicture for step3

Step 3

Use the SC545 EZ SpeedClic diamond cutting wheel when cutting out large sections of the egg. Use the 111 engraving cutter for small cuts and the 106 engraving cutter for making small holes. For very fine cuts, "score" the egg with the 106 engraving bit then cut through the score with the 111 engraving cutter. Recommended speed: 20,000 rpm.

projectpicture for step4

Step 4

Glue beads, ribbon or images to the egg to add a decorative finishing touch. Also, consider applying a painted finish. If the egg has a large, open center, you may wish to paint the interior or line it with fabric for additional flair.

related products

Other supplies


Pin (for piercing egg)

Two-part Epoxy or Craft Glue

Beads, Ribbons, Paint, Photos or Other Decorations