jump to main content

Replacing Golf Club Grips

If the grips have, well, reminder marks, be sure they're pointing toward the club head. The D-Vise is padded and will protect your club shaft from being marred. Use club grip solvent in accordance with the manufacturer's instructions.

projectpicture for step1

Step 1

Secure the club shaft in the D-Vise. Cut off old grips with the 426 cut-off wheel. Be careful that you don´t cut into the actual shaft.

projectpicture for step2

Step 2

Clean off the remains of the old tape using grip solvent. Then wrap the double-backed tape in an upward spiral, starting about 1/2" from where the low end of the grip will be.

projectpicture for step3

Step 3

After removing the tape backing from the shaft, hold the new grip with a finger covering the hole at the opposite end. Pour in the grip solvent and rock it back and forth to spread the solvent throughout the inside.

projectpicture for step4

Step 4

Pour remaining solvent on the new tape on your club shaft, making sure all the tape is wet. Quickly slide the new grip over the taped shaft as far as it will go.

related products

Other supplies

Dremel D-Vise

Replacement Grips

Roll of Golf Grip Tape

Grip Solvent