Creating greetings Card

Creating greetings Card

Project Process in steps

Step 1
Draw a scalloped edge on your card and cut it out with an ordinary pair of scissors. Using the Dremel 7700, punch holes (parchment) using the diamond wheel point around the edge of the card either in a straight line or in groups of three.

Creating greetings Card
Creating greetings Card

Step 2
Draw a borderline inside the card borders using the embossing pen and small flowers in each corner using one of the new Dremel templates. Sprinkle embossing powder over the pen lines. Shake the excess powder off.

Creating greetings Card
Creating greetings Card

Step 3
Using the Dremel VersaTip with the hot air tip, carefully emboss the powder by holding the end of the tip a few centimetres away from the card.

Creating greetings Card
Creating greetings Card

Step 4
Cut a piece of card fold it in half and glue the embossed card onto the front. Cut out a butterfly shape and decorate with the embossing pen and powder and heat with the VersaTip. Glue the butterfly body to the front of the card and raise wings away from the card to give 3D effect.

Creating greetings Card
Creating greetings Card

Other Supplies

  • Dremel stencil
  • Embossing powder
  • Embossing pen
  • Ruler
  • Selection of coloured card

Related products

Other Supplies

Other Supplies

Rate this project

https://www.dremeleurope.com/general/en/ocs/project/rate/7336
65
7336
7336
235
1
2
3
4
5
65