jump to main content

Freze de tăiere spirale (562)

Pentru tăiere „liberă” în plăci de perete (nu gresie)

Tăiere

Descrierea produsului

What can you do with it?
The 562 is designed to work on ceramic wall tile (tile suitable for use only on a wall), not for use on floor tiles. Best for cutting and drilling materials like ceramic wall tiles and mosaics

How to use?
We recommend to use this bit with the Dremel Tile Cutting Attachment, because it’s designed to help you maintain depth during the application. It’s important that the depth of the guide supports the cutting blade extending beyond the material by about 0.6 cm. (.25”). If the bit extends out too far beyond the material, it can be more difficult to control and can actually snap the bit.

Best control of the bit occurs when moving in a clockwise direction. Begin the cut at a 45 degree angle and then bring the accessory to 90 degrees.
The tool should be set at a high speed, the feed rate of the material or the tool through the material should be slow and gradual. Too much pressure will cause this accessory to get “red hot.”

Using the tip of the bit is not the best way to cut – we recommend using the sides of the bit, where the full cutting capacity of the fluting can be put to use.
Materials to use on

Wall-tile, like ceramic.
Recommended speed

Ceramic wall tile: 35.000 RPM


Ataşament
RPM
Ataşament
Cărămidă
Ceramică
Ţevi de metal
Plăci de perete

Conţinutul ambalajelor

Quantity:
1
Număr comandă
2615056232
Cod EAN:
8710364010608

specificaţii tehnice

Lungimea accesoriului
52,0 mm
RPM maxim
35.000 1/min
Diametru coadă
3,2 mm
Diametru de prelucrare
3,2 mm
Lungimea de lucru
20 mm

Informaţii de utilizare

Durabilitatea accesoriului:

1 fiind cea mai mică şi 3 fiind cea mai mare

Ataşament recomandat:

Trusă de tăiere multifuncţională DREMEL® (565)